Remove duplicated functions in fapi_vnf_p7.c, leaving only functions for messages that require usage of the secondaty data_buf for unpacking
Move vnf_info struct declaration to nfapi_vnf.h to be available in fapi_nvIPC.c
Add a function pullx32 to pull x amount of bytes into uint32_t
Change the unpacking to pull only the needed bytes, and skip over the padding, when not Aerial
Change SRS.indication dumping function to also print the report TLV contents
Change SRS.indication unitary test to fill the last 4 byte block of the report TLV according to the length, with padding
This change makes it so the fapi_nr_p7_message_pack is used to pack TX_DATA.request for Aerial, reducing the amount of repeated code.
Add the capability to pack TLVs with TAG=2 (offset from first address)
Packs the TLV.length differently according to whether or not Aerial is in use ( for Aerial TLV.length is 16-bit, for OAI is 32-bit )
Update NR P5 and P7 nFAPI headers to have 32-bit message_length
In the NR functions, this causes the header parameters following message_length to have their position shifted by 2 bytes, due to the increase in message_length size.
Change needed to accommodate SCF222.10.02 Table 3-3
Separates nfapi_p4_p5_message_header_t and nfapi_nr_p4_p5_message_header_t
Change the callbacks signature to accept/return void* intead of expecting a particular header type, being the NR/LTE distinction done inside the callback functions.
Create NR related functions for nFAPI transmit timestamp and checksum calculation.
Move nfapi_p7_codec_config_t and nfapi_p4_p5_codec_config_t to separate header to be shared between LTE and NR VNF/PNF
Move nfapi_nr_timing_info_t into NR header.
Move NR specific function declarations to NR header.
In Aerial bindings (FAPI-Aerial), the NFAPI mode must be
NFAPI_MODE_AERIAL (otherwise, we would not be executing this code).
Hence, the switches don't make sense. Remove them.
The check can more easily be checked with
git show <commit> --ignore-all-space
As is visible at the top of the patch, for compiling aerial_lib (the
binding FAPI-Aerial), we always add ENABLE_AERIAL. Thus, all the code
within ENABLE_AERIAL will be compiled; we can also simply take it out.
Expose needed (n)FAPI procedures to aerial_lib ( both P5 and P7 ) via a
header file.
Move (n)FAPI P7 packing/unpacking function interface into separate header file
Include needed headers in aerial_lib
Rúben Soares Silva