This reverts a change in commit
ccba7c875d. There is no real reason to
show this warning (the gNB will work just fine, simply not schedule
since no free HARQ) and it makes users unsure.
- Phy config update and Sidelink frame parameters initialisation
- PSBCH scheduler to trigger TX PSBCH/RX PSBCH actions
- Sidelink indication with rx ind to trigger send SL-MIB to MAC
- Enable Scope for PSBCH use -d or --dqt
- Enable system testing of PSBCH for example using RFSIMULATOR:
- UE1 is a SYNCRONISATION SOURCE UE which transmits PSBCH
started using command -
sudo ./nr-uesoftmodem --sl-mode 2 --sync-ref 4 --rfsim --rfsimulator.serveraddr server
- UE2 syncs onto UE1 during sidelink search, gets the timing and continues to receive PSBCH
started using command -
sudo ./nr-uesoftmodem --sl-mode 2 --rfsim --rfsimulator.serveraddr 127.0.0.1
- In the default use case 2 Sidelink SSBs sent over 16 frames.
- In case SL-SSB configuration needs to be changed use -O option in the above command like
-O ../../../targets/PROJECTS/NR-SIDELINK/CONF/sidelink_preconfig_1txpool.conf
It might be desirable to run the UE without superuser rights. More
concretely, it might run without NET_ADMIN. In this case, various
corresponding operations on the TUN socket fd might fail. In this
commit,
- improve error reports to make them more clear
- do not automatically exit(1), but return from the function to ensure
continuity of the softmodem
The RTT for GEO satellites is more than 500 ms.
And as the TA update interval must be greater than the RTT, we increase it to 1 second instead of 100 ms.
Should also do no harm for terrestrial networks.
According to the RRC specification, cellSpecificKoffset is:
Scheduling offset used for the timing relationships that are modified for NTN (see TS 38.213 [13]).
The unit of the field K_offset is number of slots for a given subcarrier spacing of 15 kHz.
If the field is absent UE assumes value 0
This parameter `cellSpecificKoffset_r17` can be set in the gNB conf file, in the section `servingCellConfigCommon`
There is already a command line option called 'ue-scan-carrier' which
seemed to blindly look for SSB by changing the center frequency by
+/-100Hz if the previous attempt failed. This is probably copied from
LTE and is not suitable for NR. This commit uses this option to either
1. Perform initial sync on one GSCN if the SSB position if known
2. Or scan the all GSCN (if the SSB postion is unknown)
Also, the following is done for re-synchronization
1. Scan all GSCN when UE comes back from IDLE state
2. Scan one GSCN when UE does re-estabishment
Removed dependency of lte-softmodem.h in nr-softmodem.c.
CONFIG_HLP_UESCAN is declared also in lte-softmodem.h.
Robert Schmidt