Added selection of interfaces through the configuration file with a new block of statements as follows:
FLEXSPLIT_INTERFACES :
{
DU_INTERFACE_NAME_FOR_F1U = "lo";
DU_IPV4_ADDRESS_FOR_F1U = "127.0.0.1/24";
DU_PORT_FOR_F1U = 2210;
CU_INTERFACE_NAME_FOR_F1U = "lo";
CU_IPV4_ADDRESS_FOR_F1U = "127.0.0.1"; //Address to search the DU
CU_PORT_FOR_F1U = 2210;
// One of TCP/UDP/SCTP
F1_U_TRANSPORT_TYPE = "UDP";
};
changes:
- ue mcc/mnc 208.93
- use correct key/opc for user
- change addresses in conf file for them to be easier to understand
(maybe)
With those changes, running:
sudo ./run_enb_ue_virt_s1
in cmake_targets/tools should work out of the box
The user still has to configure correct IP addresses in
targets/PROJECTS/GENERIC-LTE-EPC/CONF/enb.band7.generic.oaisim.local_mme.conf
We supposed oaisim (enb+ue) machine to be on IP address 10.0.1.1
and EPC (hss, mme, spgw) machine to be on IP address 10.0.1.2.
Several problems are present.
The first is that _write returns 0 instead of the
number of samples. We solve it by returning
nsamps.
The second is that _read may return less samples at
the beginning and we don't want to exit for that.
We solve it also by returning nsamps.
(We still need to log more in this, to be done in the
next commit.)
The third is that after initialization we don't send
anything for a while, time for the softmodem to finish
its init. This generates lots of "RX overrun".
We solve it by disabling TX and RX modules after init
and then in trx_brf_start we activate them again (and
also call bladerf_sync_config, which seems to be
mandatory, and bladerf_calibrate_dc, which may be avoided,
perhaps).
Maybe not the end of the story. Sometimes it works, UE connects,
traffic is fine (tested only with 5MHz). Sometimes it does not,
UE does not connect, or it connects but then traffic is bad,
especially uplink.
To be refined.
Raymond.Knopp