Handle IPv6 (and IPv4v6) PDU sessions by correctly instructing
nas_config() to set up the interface with provided IP addresses.
Note that as of now, IPv6 PDU sessions have not been fully tested.
Remove a useless assert at the gNB; to my understanding the gNB does not
care about the IP session type (at least for IP), as it just
transparently tunnels the IP packets from/to GTP.
I added a comment in the code where to change to request a PDU session
different from IPv4. Currently it is hardcoded to IPv4, and it seems
that a default OAI 5GC config would reject a PDU session type different
from IPv4.
These rules & route are necessary to properly send packets on oaitun_ue1
interface:
1. This forces the packets coming from a subnet different than the UE's
subnet to go back through oaitun_ue1 rather than via what the default
route defined on the system (e.g., important if ping from the
internet arrives).
2. On machines setting net.ipv4.conf.oaitun_ue1.rp_filter=1 (e.g.
RHEL), this prevents that source filtering for packets coming back is
applied and those packets be dropped. By default, many hosts have
rp_filter=2, so no strict source filtering is applied, and it would
work; on others, this rule prevents source filter dropping.
Prior to this commit, there was a global variable baseNetAddress that
could be set independently through a setter and also through the
configuration module. This baseNetAddress (16 bits IPv4) would then be
complemented with two more bytes in nas_config().
However, this is counter-productive, as not only we have a global
variable that is avoidable (we can give the entire address to
nas_config() directly), but it also would not work with IPv6. Hence,
modify to give nas_config() the entire address. A follow-up commit will
add IPv6 support.
Before this commit each time the message was captured, it entered the
default switch statement, which is meant to show that we received an
uknown IEI.
Now after the DNN IEI, we set offset=msg_length, to exit the
switch.
Guido Casati