Some more fixes for some bad conflict resolutions.
I ran:
git diff 2018.w04 2018.w05
And saw some problems with config_sib2.
There was also something strange in openair2/LAYER2/openair2_proc.c
in the function dump_eNB_l2_stats. Maybe the fix is wrong for
this one. To be checked.
Doing an iperf UDP uplink test, we could reach only 6Mb/s
with very good radio conditions instead of around 8Mb/s.
It turns out the MCS was limited to 16.
With this commit, we are back to a bit more than 8Mb/s
as it used to be.
(This is with a 5MHz bandwidth.)
Doing airplane mode off to connect a cots UE followed by airplane mode on
to disconnect it gives very bad results (bad disconnection with lots of
UL failures followed by lots of logs in the eNB). It used to work properly
after the work done by Xu Bo.
It turns out that in 2018.w04 things were still working okay. But
in 2018.w05 no.
So I ran:
git diff 2018.w04 2018.w05
And I checked all the modifications that I thought were relevant
(everything related to the UE, oaisim, if4 and fapi has not been checked).
This commits takes back the version of 2018.w04.
The modifications in openair2/RRC/LITE/rrc_eNB.c are necessary, I think.
The other modifications may not be necessary or even wrong. To be checked
at some point.
- move IMSI extraction code to function, remove FLEXRAN comp. directive
- refactor the code, esp. don't do deep if-nesting
- remove m-tmsi part (does not give correct value)
- copy complete IMSI info to UE context, decode in RAN API
Original Author: Xenofon Foukas
Changed formatting
does not compile
RS: cast to get rid of compiler warning
-> ImsiEpsMobileIdentity_t to ImsiMobileIdentity_t which is defined the same
way
The problem that may happen is that when the UE does not transmit
on PUCCH (for whatever reason) we may get no signal at all, and
thus compute a very low CQI. Later on we may ask the UE to transmit
louder which may lead to saturation and more problems.
The solution is simple: don't care about CQI in case of DTX
(and NACK also, as done for PUSCH).
Only FDD case done.
For TDD it seems that:
- nfapi structures are not correct. See nfapi_harq_indication_tdd_rel13_t
in nfapi/open-nFAPI/nfapi/public_inc/nfapi_interface.h, all the cases
(bundling, multiplex, ...) use nfapi_harq_indication_tdd_harq_data_t
- the function extract_harq does not handle TDD
Raymond Knopp