Use the CU-UP load tester to test the functionality of the CU-UP and
its loader tester. The requirements on this load test are intentionally
low, as it will be run with other unit tests in parallel, and should
still pass.
It uses an existing configuration file for the CU-UP. The test script
runs the CU-UP, runs the load tester, stops the CU-UP, and returns the
load tester return value as test result (which will be 0=success if all
packets have been received).
This is a simple CU-UP load tester. It sets up a configurable number of UEs in the
CU-UP, then sends GTP traffic in downlink/uplink in the N3-F1/F1-N3
direction at the CU-UP. It then compares the sent and received data.
Additional parameters, such as amount of traffic, test length, packet
size, and IP addresses/ports are configurable.
To run:
mkdir build && cd build && cmake .. -GNinja && ninja nr-cuup nr-cuup-load-test params_libconfig
./tests/nr-cuup/nr-cuup-load-test
./nr-cuup -O ../tests/nr-cuup/load-test.conf
The tester should be able to detect lost and reordered packets.
Example lost: Receive order 2,3,5,6 (lost packet 4)
=> on packet 2, expected 2, next=expected+1=3
=> on packet 3, expected 3, next=expected+1=4
=> on packet 5, expected 4, diff=5-4=1 (lost 1), next=payload+1=6
=> on packet 6, expected 6
=> 1 lost
Example reordered: Receiver order 2,5,3,6 (lost packet 4)
=> on packet 2, expected 2, next=expected+1=3
=> on packet 5, expected 3, diff=5-3=2 (lost 2), next=payload+1=6
=> on packet 3, expected 6, (reduce lost by 1 to 1), next=expected=6
=> on packet 6, expected 6
=> 1 lost
Example reordered: Receiver order 2,5,3,4,6 (no losses)
Robert Schmidt