RRC Version is a required IE. Hence, implement the encoder and decoder
for this message. At the DU and CU, read the RRC Version we use and fill
the corresponding field.
Co-authored-by: Robert Schmidt <robert.schmidt@openairinterface.org>
For LiteOn DU, we do not receive the MIB/SIB1 in the F1 Setup Request.
This is not a problem in itself, but it might happen that certain
procedures are executed without MIB/SIB1. Check for it and handle
appropriately:
- During normal connection establishment, we might not be able to
calculate measurement config
- During reestablishment, we might not be able to calculate ARFCN SSB
and cannot do reestablishment; do RRC setup instead.
MR-2401 changed the argument to the init_nrUE_standalone_thread
to be zero instead of the ue_id_g. This causes every port to be
opened for multiple UEs to have the same value, therefore only
allowing one UE to be connected to the proxy. If the ue_id_g
global is an issue, we should open a new ticket for a proper fix.
When setting up bearer(s) through F1, the corresponding F1 message has
QoS fields for the DRB(s) to be set up, as well as for all flows
associated to this DRB. In this commit, set the DRB QoS field to be
equal to the first flow (it is unclear/unspecified how it should be set
up, based on the flows), which was not set before and therefore
contained unitialized data.
The F1 module uses this data, and in split mode, F1 message generation
failed due to uninitialized data.
We reuse RRC UE IDs at the RRC. Previous to this commit, we did not
release a UE at the CU-CP's PDCP (for SRBs). Thus, when reconnecting a
UE, the PDCP might not be in a good state, since we did not release the
previous PDCP UE context.
remove several unused files
remove mem_block_t that is never used in a different way than a simple heap buffer
move up IP address type and remove duplications of the same struct declaration
Position of SSB from Point A depends on offsetToPointA and Kssb, and for both, the unit for RB is expressed as 15KHz for FR1 and 60 KHz for FR2, so scaling must be 4 for FR2 frequencies
- Implement: Extend the F1 encoding and decoding with Qos
- Implement: E1 decoding for QoS
- Fix: Modify the UE_MODIFICATION_REQUEST_MSG towards DU to contain QoS info based on E1AP context response
- Fix: Modify the E1AP and F1AP message structures
- Fill the Qos configuration to send to MAC
A COTS UE is sending UE capabilities with accessStratumRelease "rel16"
which is not decoded by our RRC. Switching to RRC 16.13.0 lets our RRC
accept these capabilities (and as a positive side effect lets this
particular UE work nicely in NSA fr1).
francescomani