This resolves the following warning:
"error: invalid suffix on literal; C++11 requires a space between literal and
identifier"
Since this file might be included from a C++11 file. It only adds spaces.
end_of_burst_delay is used to stop TX only "after a while".
If we stop right after effective signal, with USRP B210 and
B200mini, we observe a high EVM on the S subframe (on the
PSS).
A value of 400 (for 30.72MHz) solves this issue. This is
the default.
This default value can be changed in the configuration file.
For example:
RUs = (
{
local_rf = "yes"
nb_tx = 1
nb_rx = 1
att_tx = 20
att_rx = 0;
bands = [7];
max_pdschReferenceSignalPower = -27;
max_rxgain = 105;
eNB_instances = [0];
sf_extension = 312;
end_of_burst_delay = 200;
}
);
Here we would set a value of 200.
The value to put in the configuration file is for
30.72MHz. The value is scaled accordingly at runtime
(thus only one value to set for every RB configuration,
25, 50 or 100, leading to less problems when adapting
configuration files).
This option is for experts and should not be changed
randomly.
This parameter is meaningful in TDD, to decide
when to start DL at eNB side. Since there is a
need for the PA to be operational, we need to
transmit a bit before the DL subframe coming
after an UL subframe. (We transmit zeros.)
We used to use N_TA_offset which may be too much.
Default value is now N_TA_offset/2 and can be
changed in the configuration file, in the RUs
section, like:
RUs = (
{
local_rf = "yes"
nb_tx = 1
nb_rx = 1
att_tx = 0
att_rx = 0;
bands = [7];
max_pdschReferenceSignalPower = -27;
max_rxgain = 105;
eNB_instances = [0];
sf_extension = 312;
}
);
N_TA_offset is 624 (for 30.72MHz). In the example
above, we set sf_extension = 312, which is also
the default.
The value to put in the configuration file is for
30.72MHz. The value is scaled accordingly at runtime
(thus only one value to set for every RB configuration,
25, 50 or 100, leading to less problems when adapting
configuration files).
This option is for experts and should not be changed
randomly.
This commit introduces X2AP timers (t_reloc_prep, tx2_reloc_overall).
You need to set the values in the configuration file.
X2AP can be enabled or disabled in the configuration file too (disabled
by default).
Some deadcode was removed.
Some deadcode was removed.
The implementation of the ID management is not finished.
It will only work if the handover is successful. No error
recovery has been done. For error recovery, we need to
implement the X2AP timers. As it is, in case of error, an ID
might very well never be released.
It has been tested with 1 and 2 UEs doing handover more or less
at the same time.
- manage target eNB based on target cell id received by measurement report
for Handover Request
- manage source eNB based on association id for Handover Request Ack
- use only x2ap instance and not x2ap data instance points to x2ap instance
- free correctly in rrc_eNB_free_mem_UE_context
- check for existence of ue_context.handover_info in rrc_enb_process_itti_msg
- check return value sctp_peeloff in sctp_handle_new_association_req_multi
and exit in case of failure
Louis Adrien Dufrene