For whatever reason we need N_TA_offset to be 0 for the basic simulator
to function properly.
This is more a hack than a proper solution. More analysis is needed
to understand what happens and what should be really done.
* join pthread_FH (ru_thread) once all condition variables have been set
* join RU FHTX only if it has been started (check as for pthread_create())
* join PRACH thread in the monolithic case
* send broadcast on condition variable cond_eNBs, as there can be multiple
waits on it
* integrate stop_ru(*ru) into kill_RU_proc(*ru)
* Correct memory freeing
* init_td_thread()/init_te_thread() are only initialized depending on condition
get_nprocs() > 2 && codingw
* apply the same the same for the functions kill_td_thread()/kill_te_thread()
Various problems were found with the basic simulator.
Variables used by various threads for synchronization need to
be initialized properly. That is before the various threads
start using them.
This goes for:
- UE->is_synchronized
- UE->proc.instance_cnt_synch
- UE->proc.instance_cnt_rxtx
The function "UE->rfdevice.trx_start_func" was called in
"UE_thread_synch" but should be called in "UE_thread" because
"UE_thread" is the one that calls "UE->rfdevice.trx_read_func"
and there is no guaranty that the call to "UE->rfdevice.trx_start_func"
is done before as it has to (it's in another thread).
And finally "pthread_cond_signal(&proc->cond_rxtx)" was called twice,
which may not be a problem but was certainly not intended. Plus
removing one call simplifies the code by removing some "if" logic,
which is a good thing per se.
This commit was not tested with a real UE and may thus introduce some
issues. Hopefully not!
Before this commit we were checking for UE->is_synchronized == 0
then we were waiting for a potentially active synch routine to
finish and then we were starting the synch routine again but the
synch routine that was running may have set UE->is_synchronized
to 1. This was leading to various problems, most notably the following
message repeated over and over in the UE log and the UE unable to
connect properly:
[RRC] [UE 0] Frame 377: OUT OF SYNC FROM eNB 0 (T310 active 0 : T310 0, N310 345, N311 0)
So let's wait for a potentially active synch routine to finish
before anything else.
Y_Tomita